Small Block Chevrolet INSTALLATION INSTRUCTIONS Engine Prep: Disconnect battery Remove existing alternator, a/c compressor, and brackets.
DO NOT TILT, SHAKE OR TURN REFRIGERANT CAN UPSIDE DOWN DURING THE CHARGING PROCESS WHILE THE ENGINE IS RUNNING! Evacuate the system for a minimum of 4
Note: Use the double nuts provided for install if needed. Install Compressor and Alternator Brackets: 1. Install four large and two sm
Install Water Pump and Spacer Posts: 1. Slide water pump over studs. 2. Apply anti seize to the end of the studs. 3. Instal
4. Install three remaining (2.69”) spacer posts. Note: Tighten all spacer posts and two cap screws at this time. Install Main Bracket: 1.
WARNING: Do not start the engine until power steering hoses, reservoir, fluid, etc are installed and system is filled and bled. See the enclosed in
Install Alternator: 1. Install alternator using one M8 x 25mm and one M10 x 80mm cap screws and washers with anti seize. Tighten shoulder bol
1. Install crank pulley using three 3/8-24 x 1” cap screws and Belleville washers as shown with thread locker. Install Tensioner and Belt: 1
Install Compressor Manifold: Do not perform this step until you are ready to install AC lines and charge your system! 1. Remove the plate on
PLEASE READ! IMPORTANT INFORMATION ABOUT YOUR POWER STEERING PUMP Follow these procedures to ensure that the system is filled and purged correctly. P
Comments to this Manuals