1 LS Chevrolet INSTALLATION INSTRUCTIONS Engine Prep: Disconnect battery Remove existing accessory drive and
10 PLEASE READ! IMPORTANT INFORMATION ABOUT YOUR POWER STEERING PUMP Follow these procedures to ensure that the system is filled and purged correctl
11 minutes for liquid to “boil off,” or hand turn the compressor hub (not the pulley) a minimum of 10 complete revolutions to clear liquid refrigeran
2 Install Water Pump and Rear Alternator Bracket: 1. Install three M8 studs x 92 mm with anti seize to the passenger side of the block. They should
3 4. Install three 3/4 x 2.55 spacer posts with anti seize to passenger side studs. 5. Install rear alternator bracket and two 3/4 x 1.41 spacer
4 Install Rear Compressor Bracket: 1. Attach rear compressor bracket to water pump using two M10 cap screws x 20mm with anti seize. Ins
5 2. Install compressor lower shoulder bolt with anti seize. Note: Tighten shoulder bolt and five M8 cap screws at this time. 3. Install compr
6 Install Alternator: 1. Install alternator using one M8 x 25mm cap screw and one M10 x 80mm cap screw with washers and anti seize. No
7 Install Power Steering Pump: 1. Install three M10 x 25mm set screws with thread locker to the engine block on the lower driver side. They shoul
8 4. Install power steering pump with pulley using two 5/16-18 x 3 cap screws and lock washers with thread locker. WARNING: Do not sta
9 3. Install tensioner cover using two 10-32 x ¾ flat head screws with thread locker. Install Compressor Manifold: Do not perfo
Comments to this Manuals